Specifications

Installation

801509

Location Requirements

Select a location with a solid, sturdy and level floor.

Do not install unit on carpeting, soft tile, pedestal, a

platform or other weakly supported structure.

The unit must not be installed or stored in an area

where it will be exposed to water and/or weather.

Leveling legs can be adjusted from inside the unit with

a 0.875 inch deep well socket. All four legs must rest

firmly on the floor so the weight of the unit is evenly

distributed. The unit must not rock and must be level

from side-to-side and front-to-back.

IMPORTANT: Unless completely assembled, DO

NOT slide the unit across the floor. DO NOT slide

the unit more than 1.2 m (4 feet) once the leveling

legs have been extended, as the legs and the base

could become damaged.

The unit needs sufficient clearance and an adequate air

supply for proper operation and ventilation, and for

easier installation and servicing. (Minimum clearances

are shown in Figure 27.)

Figure 27

SWD698N

NOTE: Shaded areas indicate adjacent structure.

SWD698N

Dryer and Exhaust Duct Clearances

Area Description Minimum Clearance

A Left Dryer Side 0 cm (0 in.)

B Right Dryer Side 2.54 cm (1 in.)

C Dryer Top 15.24 cm (6 in.)

D Dryer Rear 10.2 cm (4 in.)

E Exhaust Duct Clearance to Combustible Material 5.1 cm (2 in.)