Specifications

Installation

801509

Step 6: Position and Level the Unit

Place unit in position on a solid, sturdy and level floor.

Installing the unit on any type of carpeting, soft tile,

pedestal, a platform or other weakly supported

structure is not recommended.

Loosen 0.875 inch locknut and adjust the front and

rear leveling legs until the unit is level from side to

side and front to back (using a level). Unit should not

rock.

NOTE: Level must rest on raised portion of top

panel. Refer to Figure 13.

NOTE: DO NOT slide unit more than 1.2 meters

(4 feet) across floor if the leveling legs have been

extended, as legs and base could become damaged.

NOTE: Use of the dispenser drawer or washer or

dryer doors as handles in the transportation of the

unit may cause damage to the dispenser or doors.

Remove rubber cups from accessories bag and place

on all four leveling legs.

NOTE: For further assistance, refer to section on

Location Requirements.

Verify that unit does not rock.

Figure 13

Units elevated above floor level must be

anchored to that elevated surface, base or

platform. The material used to elevate the

unit should also be anchored to the floor to

ensure that the unit will not walk or that the

unit can not be physically pulled, tipped or

slid from its installed position. Failure to do

so may result in conditions which can

produce serious injury, death and/or

property damage.

W307

WARNING

SWD693N

1 Leveling Leg

2 Unit Base

3 Level

4 Locknut

5 Rubber Cup

SWD693N