Specifications

ManualsBrandsAlliance Laundry Systems ManualsWashersSWD444C

Installation

801509

Installing the Unit

Step 1: Position Unit Near Installation

Area

NOTE: If the unit is delivered on a cold day (below

freezing), or is stored in an unheated room or area

during the cold months, do not attempt to operate

it until the washer has had a chance to warm up.

Move unit so that it is within 1.2 meters (4 feet) of the

desired area of installation.

NOTE: For best performance and to minimize

vibration or movement, install unit on a solid,

sturdy and level floor. Some floors may need to be

reinforced, especially on a second floor or over a

basement. Do not install the unit on carpeting, soft

tile, pedestal, a platform or other weakly supported

structure.

Figure 3

Step 2: Connect Water Fill Hoses

NOTE: Refer to section on Water Supply

Requirements before connecting water fill hoses.

The appliance is to be connected to the water mains

using new hose-sets. Old hose-sets should not be

reused.

Turn on the water supply faucets and flush the lines for

approximately two minutes to remove any foreign

materials that could clog the screens in the water

mixing valve.

NOTE: When installing in newly constructed or

renovated building, it is very important to flush the

lines since build-up may have occurred during

construction.

Remove the two filter screens and the two plain rubber

washers from the accessories bag.

Insert each filter screen into the end of each fill hose

that will connect to the water supply faucet. The screen

must be facing outward. Refer to Figure 4.

Insert each plain rubber washer into the other end of

each fill hose that will connect to the water mixing

valve at the rear of the washer. Refer to Figure 4.

IMPORTANT: Thread hose couplings onto valve

connections finger-tight, then approximately

1/4 turn with pliers. DO NOT cross thread or

overtighten couplings.

Turn water on and check for leaks. If leaks are found,

retighten the hose couplings. Continue tightening and

rechecking until no leaks are found.

Figure 4

SWD706N

Washer and dryer are not designed to be

operated as separated, side-by-side units.

W187

CAUTION

SWD706N

TLW1976N

1 Water Faucet

2 Fill Hoses

3 Plain Rubber Washer

4 Filter Screens

HOT

COLD