Specifications

Installation
9
801509
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Before You Start
Tools
For most installations, the basic tools you will need
are:
Figure 1
Water
Washer needs two standard 19.1 mm (0.75 inch) water
supply faucets with a pressure between 138 and
827 kPa (20 to 120 pounds per square inch). For more
detailed information, refer to section on Water Supply
Requirements.
Gas
Dryer is equipped for Natural Gas with a 0.375 inch
NPT gas supply connection. For more detailed
information, refer to section on Gas Requirements.
Location
Place the unit on a solid floor with an adequate air
supply. For more detailed information, refer to section
on Location Requirements.
Exhaust
Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
NOTE: For more detailed information, refer to
section on Dryer Exhaust Requirements.
Figure 2
Electrical
NOTE: Single electrical connection serves both
washer and dryer.
● ELECTRIC DRYER
Unit needs a 3 wire and ground, 120/240 or
120/208 Volt, 40 Amperes, 60 Hertz, AC single
phase electrical supply. For more detailed
information, refer to section on Electrical
Requirements.
● GAS DRYER
Unit needs a 120 Volt, 20 Amperes, 60 Hertz,
polarized 3-slot effectively grounded receptacle.
For more detailed information, refer to section on
Electrical Requirements.
NOTE: 208 Volt heating element is available (as
optional equipment at extra cost).
D814I
1 Wrench
2 Screwdrivers
3 Pliers
4 Socket Wrench
5 Tef l o n Ta p e
6 Level
7 Duct Tape
1 2 3
4
5
6
7
SWD442
S