Instruction manual

65
501506
Section XI
Sales Floor Feature
The Sales Floor Feature turns on the entire VFD
display including all status words, LEDs, and the
three 7-segment digits.
How to Enter Sales Floor Feature
1. Be sure the dryer is in the “Ready” mode
before continuing to step 2. See Figure 3.
If the dryer is in an active cycle, rapid advance
through the cycle, see the Rapid Advance
feature, (Section XII). If coins have been
entered, see the Clear Vend feature (Section
XIII ).
2. Open and close the service door. Refer to
Section VI .
3. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. The VFD will show “SPC,”
Figure 101 .
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
FABRICS AND TEMPERATURES
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C145IE1A
Figure 101
4. While pressing and holding the START pad
with one hand, press the MED TEMP pad with
the other hand. The display will light up.
How to Exit Sales Floor Feature
1. Be sure service door has been opened and
closed. Refer to Section VI.
2. While pressing and holding the START pad
with one hand, press the MED TEMP pad with
the other hand.