Instruction manual

57
501506
28. Set Real-Time Clock (month)
“COn”
This option allows the user to set the Electronic
Control’s internal clock to the correct month.
How to Program Set Real-Time Clock
(month) “COn”
1. Control must be in Special Mode. Refer to
Section VII.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. Programmable option
number 1 (Audio Signal “SIg”) will appear in
the VFD, Figure 90 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C146IE1A
Figure 90
3. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to scroll through the
programmable options until “COn” appears in
the VFD, Figure 91 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C174IE1A
Figure 91
4. When “COn” appears in the VFD, press the
START pad. The current month will be
displayed.
5. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to increase or decrease the
month until correct, Figure 92 .
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
Press this pad to
scroll ahead or
increase (+) values
Press this pad to
scroll back or
decrease (-) values
Press this pad to
choose (enter) selected
options or values
C147IE1A
Figure 92
6. When the correct month appears in the VFD,
press the START pad to enter the corrected
month. The next programmable option, “CYr,”
will appear in the VFD.
NOTE: To program “CYr” (Set Real-Time Clock
Year), see the following page. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure service door has been opened and
closed. Refer to Section VI.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. The control will revert
back to the “Ready” mode. See Figure 3 .