Instruction manual

54
501506
5. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to increase or decrease the
hours to the correct time, Figure 83 .
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
Press this pad to
scroll ahead or
increase (+) values
Press this pad to
scroll back or
decrease (-) values
Press this pad to
choose (enter) selected
options or values
C147IE1A
Figure 83
6. When the correct time in hours appears in the
VFD, press the START pad to enter the
corrected time. The next programmable option,
“CdA,” will appear in the VFD.
NOTE: To program “CdA” (Set Real-Time Clock
Days of Week), see the following page. To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
1. Be sure service door has been opened and
closed. Refer to Section VI.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. The control will revert
back to the “Ready” mode. See Figure 3 .
25. Set Real-Time Clock (hours)
“CHr”
This option allows the user to set the Electronic
Control’s internal clock to the correct time in hours.
How to Program Set Real-Time Clock
(hours) “CHr”
1. Control must be in Special Mode. Refer to
Section VII.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. Programmable option
number 1 (Audio Signal “SIg”) will appear in
the VFD, Figure 81 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C146IE1A
Figure 81
3. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to scroll through the
programmable options until “CHr” appears in
the VFD, Figure 82 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C171IE1A
Figure 82
4. When “CHr” appears in the VFD, press the
START pad. The current time in hours will be
displayed.
NOTE: Hours are displayed in military time.