Instruction manual

38
501506
6. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to increase or decrease the
current three-digit number displayed in the
VFD to the desired three-digit number in
Chart 3 , Figure 44 .
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
Press this pad to
scroll ahead or
increase (+) values
Press this pad to
scroll back or
decrease (-) values
Press this pad to
choose (enter) selected
options or values
C147IE1A
Figure 44
7. Press the START pad when the correct three-
digit number appears in the VFD. The next
programmable option, “PCL,” will appear in the
VFD.
NOTE: To program “PCL” (MED TEMP
Temperature), see the following page. To program
other options, refer to the appropriate section.
HIGH TEMP Temperature “HdE”
HIGH TEMPERATURE VALUE CHART
VALU FAHRENHHEIT TEMP CELSIUS TEMP
000 130°F 54°C
001 135°F 57°C
002 140°F 60°C
003 145°F 63°C
004 150°F 66°C
005 155°F 68°C
006 160°F 71°C
CHART 3
How to Exit Programming Feature
1. Be sure service door has been opened and
closed. Refer to Section VI.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. The control will revert
back to the “Ready” mode. See Figure 3 .
12. HIGH TEMP Temperature
“HdE”
This option allows the user to set the maximum
temperature in the HIGH TEMP cycle.
How to Program HIGH TEMP Temperature
“HdE”
1. Control must be in Special Mode. Refer to
Section VII.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. Programmable option
number 1 (Audio Signal “SIg”) will appear in
the VFD, Figure 42 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C146IE1A
Figure 42
3. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to scroll through the
programmable options until “HdE” appears in
the VFD, Figure 43 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C158IE1A
Figure 43
4. When “HdE” appears in the VFD, press the
START pad. A three-digit number will appear
in the VFD.
NOTE: The number appearing in the VFD is the
current number that was selected from Chart 3 on
this page.
5. Locate the desired three-digit number in the
first column of Chart 3 .