Instruction manual

35
501506
9. Special Vend A, End Hour
“AEH”
This option allows the user to set the hour that Special
Vend A will end. The start and end hour programmed
for a special vend must be within the same day.
How to Program Special Vend A End Hour
“AEH”
1. Control must be in Special Mode. Refer to
Section VII.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. Programmable option
number 1 (Audio Signal “SIg”) will appear in
the VFD, Figure 33 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C146IE1A
Figure 33
3. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to scroll through the
programmable options until “AEH” appears in
the VFD, Figure 34 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C155IE1A
Figure 34
4. When “AEH” appears in the VFD, press the
START pad. The current end hour (in military
time) will appear in the VFD.
5. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to increase or decrease the
current end hour to the desired end hour,
Figure 35 .
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
Press this pad to
scroll ahead or
increase (+) values
Press this pad to
scroll back or
decrease (-) values
Press this pad to
choose (enter) selected
options or values
C147IE1A
Figure 35
6. When the correct end hour appears in the
VFD, press the START pad to enter the
corrected end hour. The next programmable
option, “nCL,” will appear in the VFD.
NOTE: To program “nCL” (Normal Cycle HIGH,
MED, LOW Time), see the following page. To
program other options, refer to the appropriate
section.
How to Exit Programming Feature
1. Be sure service door has been opened and
closed. Refer to Section VI.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. The control will revert
back to the “Ready” mode. See Figure 3 .