Instruction manual

34
501506
8. Special Vend A, Start Hour
“ASH”
This option allows the user to set the hour that Special
Vend A will begin. The start and end hour
programmed for a special vend must be within the
same day.
How to Program Special Vend A Start
Hour “ASH”
1. Control must be in Special Mode. Refer to
Section VII.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. Programmable option
number 1 (Audio Signal “SIg”) will appear in
the VFD, Figure 30 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C146IE1A
Figure 30
3. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to scroll through the
programmable options until “ASH” appears in
the VFD, Figure 31 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C154IE1A
Figure 31
4. When “ASH” appears in the VFD, press the
START pad. The current start hour (in military
time) will appear in the VFD.
5. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to increase or decrease the
current hour to the desired hour, Figure 32 .
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
Press this pad to
scroll ahead or
increase (+) values
Press this pad to
scroll back or
decrease (-) values
Press this pad to
choose (enter) selected
options or values
C147IE1A
Figure 32
6. When the correct hour appears in the VFD,
press the START pad to enter the corrected
hour. The next programmable option, “AEH,”
will appear in the VFD.
NOTE: To program “AEH” (Special Vend A End
Hour), see the following page. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure service door has been opened and
closed. Refer to Section VI.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. The control will revert
back to the “Ready” mode. See Figure 3 .