Instruction manual

22
501506
1. Audio Signal “SIg”
This option allows the user to program when the
signals will sound and at what volume level.
There are three occasions where a signal may sound
during the dryer operation. These three occasions
are listed below:
1. End of Cycle Signal
By default, this signal is turned off. If turned
on, the signal will sound for three seconds at
one of three programmable volume levels at
the end of a cycle.
2. Keypad Depression Signal
By default, this signal is set at the lowest
volume level and will sound for .25 seconds.
This signal will sound each time a keypad is
pressed.
3. Coin Drop Signal
By default, this signal is off. If turned on, the
signal will sound for .25 seconds at one of
three programmable volume levels each time a
coin is entered.
How to Program the Audio Signal “SIg”
1. Control must be in Special Mode. Refer to
Section VII.
2. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand. Programmable option
number 1 (Audio Signal “SIg”) will appear in
the VFD, Figure 10 .
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C146IE1A
Figure 10
3. When “SIg” appears in the VFD press the
START pad. A three-digit number will appear
in the VFD.
NOTE: The number appearing in the VFD is the
current number that was selected from
Chart 1
located on the following page.
4. Locate the desired three-digit number in the
first column of Chart 1 on the following page.
5. Press the LOW TEMP (+) pad or the NO
HEAT (–) pad to increase or decrease the
current three-digit number until correct,
Figure 11 .
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
Press this pad to
scroll ahead or
increase (+) values
Press this pad to
scroll back or
decrease (-) values
Press this pad to
choose (enter) selected
options or values
C147IE1A
Figure 11
6. Press the START pad when the correct three-
digit number appears in the VFD. The next
programmable option, “nPr,” will appear in the
VFD.
NOTE: To program “nPr” (Normal Vend Price), see
option 2. To program other options, refer to the
appropriate section.
For example: A user might wish to have the signal
sound only when a keypad is pressed and at the
lowest level. Entering the three-digit number 035 in
step 4 would disable all the options except LOW
VOLUME and KEYPAD. In this instance the signal
would sound at the lowest volume only when a
keypad is pressed.
How to Exit Programming Feature
1. Be sure service door has been opened and
closed. Refer to Section VI.
2. While pressing and holding the HIGH
TEMP pad with one hand, press the MED
TEMP pad with the other hand. The control
will revert back to the “Ready” mode. See
Figure 3 .