Instruction manual

19
501506
Section VII
Entering the Special Mode
Overview
For programming, testing, and retrieving information
from the Electronic Control, it is often necessary to
enter the Special Mode by following the four simple
steps below.
How to Enter the Special Mode
1. Be sure the dryer is in the “Ready” mode,
before continuing to step 2. See Figure 3 . If
the dryer is in an active cycle, rapid advance
through the cycle, see the Rapid Advance
feature, (Section XII). If coins have been
entered, see the Clear Vend feature (Section
XIII).
2. Open and close the service door (see
Section VI).
3. While pressing and holding the HIGH TEMP
pad with one hand, press the MED TEMP pad
with the other hand.
4. The VFD will show “SPC,”
Figure 9 .
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
FABRICS AND TEMPERATURES
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C145IE1A
Figure 9
The rest of this section describes the six special
features that the Electronic Control can enter. It is
necessary to enter the Special Mode when
programming special features 1–4 in the list
below.
1. Programming the Electronic Control
2. Collecting Audit Information
3. Testing Machine and Electronic Control
Functions
4. Sales Floor Feature
5. Rapid Advance Feature
6. Clearing the Electronic Control Vend Feature
Once in the special mode, continue on into one of the
features described in detail on the following pages.
Instructions on how to exit each feature are found at
the end of each feature description.