Instruction manual

11
501506
Section IV
Dryer Operation
Start Up
Whenever power is applied to the dryer, the Electronic
Control becomes active and lights the default cycle
LED (MED TEMP). In addition, the status words
PRICE and INSERT COINS are lit with the MED
TEMP vend price displayed. This is referred to as the
“Ready” mode, Figure 3 .
The customer may select a different cycle if desired.
The VFD display will show the current vend price for
each cycle chosen. A customer may select the cycle
before entering coins.
“Ready” Mode
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
FABRICS AND TEMPERATURES
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C140IE1A
Figure 3
As coins are entered into the machine, the vend price
remaining to be satisfied gets smaller. Once the full
vend price is satisfied, the INSERT COINS and
PRICE status words are turned off, the TIME
REMAINING and PUSH START status words turn on,
and the display shows the time remaining in the MED
TEMP cycle, Figure 4.
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
FABRICS AND TEMPERATURES
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C141IE1A
Figure 4
If the START pad is pushed, the dryer cylinder will
begin turning. After the cylinder begins turning, the
heat will turn on. Also, the PUSH START status word
will go off, the DRYING status word will turn on, and
the display will begin counting down the time
remaining in the cycle.
The status word DRYING will remain lit until the
COOL DOWN cycle begins. When the COOL DOWN
cycle begins, the status word COOL DOWN is lit,
DRYING is turned off, and the heater is turned off.
The time will continue to count down until “:00”
minutes is displayed, Figure 5 . At this point the cycle
is complete.
NORMAL
HIGH
TEMP
PERM
PRESS
MED TEMP
DELICATES
LOW
TEMP
TUMBLE
NO
HEAT
START
FABRICS AND TEMPERATURES
DRYING
DOOR OPEN
COOL DOWN
PRICE
TIME REMAINING
INSERT COINS
PUSH START
C142IE1A
Figure 5