Service manual

60 800793
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer is properly grounded.
W003
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
39. INNER BASKET ASSEMBLY
a. Model LTS85A*H Only:
NOTE: Front edge of cabinet top is held in place by
two spring clips located on top flange of front panel.
Refer to Figure 10.
(1) Insert putty knife between cabinet top and
top edge of front panel (approximately
three inches in from side). Refer to
Figure 10.
(2) Push in on putty knife and at the same time
lift front edge of cabinet top. Repeat for
opposite side.
b. All other models:
(1) While supporting the lower access panel,
remove two screws from bottom edge of
lower access panel. Refer to Figure 9.
(2) Gently lower the access panel to disengage
panel locators from bottom edge of front
panel.
(3) Using the special tool, No. 318P4, remove
dispenser drawer. Refer to Figure 12.
(4) Remove two screws on top right side of
front panel (above dispenser drawer), top
left two screws and then bottom two front
corner screws. Refer to Figure 13.
(5) Unplug wire harness from both the door
latch switch and from the door switch.
Refer to Figure 16. Remove clips holding
wire harness and door seal hose along top
flange of front panel and remove front
panel.
NOTE: Door seal hose and wire harness must be
reinstalled in the appropriate clips and holes along
top flange of front panel. Refer to Figure 16.
(6) Open loading door. Carefully remove wire
clamp ring from groove with small flat
screwdriver. Spring is in 6 o’clock position.
Refer to Figure 14.
NOTE: To avoid damage to spring, use screwdriver
on wire clamp ring to the right or left of spring.
(7) Grasp loading door seal lip. Refer to
Figure 15, Step 1.
NOTE: To avoid damage to door seal, DO NOT use
pliers or sharp objects to grasp the door seal lip. If
lip is damaged, seal will leak.
(8) Using a circular motion, pull seal up
(Figure 15, Step 1), out (Figure 15, Step 2)
and down (Figure 15, Step 3).
(9) When seal releases from lip of front panel,
pull out and remove the seal. Refer to
Figure 15, Step 4.
NOTE: The ease of installation of the loading door
seal can be improved using water or 409 lubricant to
work seal around circumference of loading door. Be
sure to orientate seal with the white arrow in the 12
o’clock position when installing the wire clamp ring
to front panel. Be careful not to overstretch tension
spring.
(10) Remove two screws holding front panel to
washer cabinet.
(11) Remove front panel (with loading door
attached) away from washer as far as wires
permit.
(12) Remove two cabinet top hold down screws.
c. If area or space permits, lift cabinet top to a
vertical position (top will rest on hinges).
NOTE: To avoid damage to hinges, be sure to
support top with a chain (not included) or
equivalent. Refer to Figure 11.
d. Run belt off pulley while slowly turning pulley.
e. Remove belt from motor shaft.
f. Remove cap screw (left hand thread),
lockwasher and flat washer holding pulley to
inner basket shaft. Refer to Figure 22.
g. Remove pulley front shaft.
NOTE: When installing pulley, always use a new
cap screw to prevent screw from loosening during
operation.