Service manual

56 800793

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer before servicing.

• Never start the washer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer is properly grounded.

W003

WARNING

IMPORTANT: Always replace seal with a new seal.

Spray or apply a mixture of diluted laundry

detergent to assist in installation of new seal. The

“puffy” side of seal should be installed to the inside.

For best results, tap clamp ring all around while

tightening screw and nut.

NOTE: Install metal clamp ring by placing clamp

ring opening at approximately the 10 o’clock

position to ensure that no interference is

encountered with side panel or the underside of the

cabinet top. Tighten the clamp ring screw and nut

until a spacing of one inch is achieved at the clamp

ring opening or until tight.

Figure 21

FLW1116S

CLAMP

RING

SCREW

SEAL

OUTER TUB

FRONT PANEL

GROUND

WIRE

WASHERS

NUT