Service manual

800793 53

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer before servicing.

• Never start the washer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer is properly grounded.

W003

WARNING

g. Gently pull door lock out through door opening.

Remove door lock only far enough to

disconnect harness connector from door lock.

Refer to Figure 16.

NOTE: When installing new door lock, be sure to

install small lip through mounting hole first and

then rotate lock into position.

35. THERMOSTAT (Models equipped with

heater)

a. While supporting lower access panel, remove

two screws from bottom edge of panel and

remove panel. Refer to Figure 9.

b. Remove wire connector from thermostat.

c. Reach up behind front panel, grasp thermostat,

and using a twisting motion, pull thermostat

and rubber grommet out of mounting hole in

outer tub front panel. Refer to Figure 19.

NOTE: The thinner portion of grommet is inserted

into outer tub front panel.

NOTE: The thermostat is installed into grommet

with No. 27615P Sealant (3M800). (Obtain from

local parts distributor).

Figure 19

FLW1644S

THERMOSTAT

GROMMET

HEATING

ELEMENT

ASSEMBLY

NUT AND

LOCKWASHER