Service manual

800793 37

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer before servicing.

• Never start the washer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer is properly grounded.

W003

WARNING

15. TIMER

a. Unscrew timer knob from timer shaft (right

hand thread), then remove timer knob skirt.

b. Remove three screws holding rear of hood

assembly to control hood rear panel. Refer to

Figure 5.

c. Pivot hood assembly forward on cabinet top.

Refer to Figure 5.

d. Remove two screws holding timer to control

hood mounting plate. Refer to Figure 7.

NOTE: DO NOT attempt to repair timer.

e. Disengage wire harness terminal block plugs

from timer by pressing in on movable locking

tabs (located on each side of terminal block

plug) and pulling away from timer. Refer to

Figure 7.

IMPORTANT: To avoid an open circuit, DO NOT

pull on terminal block wires when removing blocks

from timer as this could damage wires or terminal

crimping.

Before attaching wire harness terminal blocks to

timer, make sure all male terminals on timer are

straight and are capable of accepting terminals

from wire harness terminal blocks.

Figure 7

TIMER

W427SE3A

CONTROL

HOOD

ASSEMBLY

TIMER

ATTACHING

SCREWS

LOCKING TAB

TERMINAL

BLOCK

PLUG