Service manual

53273 47
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Section 5
Adjustments
60. TIMER KNOB INDICATOR JE2870 AND
JG2880
a. With timer knob indicator in top off position,
push in and hold start switch button. Slowly
turn timer knob clockwise only until dryer
starts. Then immediately open the loading door
to stop dryer.
b. If dryer starts with indicator still in the off
position, proceed as follows:
(1) Hold knob firmly and move indicator and
plate one “click” in a clockwise direction.
Check position in reference to the right
hand vertical line of the off position.
(2) If indicator is still in the off portion of dial,
move it one more “click” in a clockwise
direction.
(3) Repeat this adjustment until the indicator is
on the right hand vertical line of the off
position.
c. If dryer starts with indicator past the right hand
vertical line of the off position, follow
instructions of “step b” above EXCEPT move
indicator and plate in a counterclockwise
direction one “click” at a time until indicator
and right hand vertical line of off position
match up.
61. LEVELING LEGS
a. Thread locknuts, Figure 41, down to heads of
leveling legs, then thread legs into dryer base
until heads extend out of base approximately
3/4 inch (19.05 mm).
b. Turn legs in or out of base as necessary to level
dryer. All four legs must rest firmly on the
floor.
c. Tighten locknuts, Figure 41, securely against
dryer base and place rubber pads on each leg.
62. BURNER FLAME (GAS MODELS)
a. Through Serial No. S840L627 - Insert key into
access door lock and turn one quarter turn
counterclockwise. Refer to Figure 11.
b. Starting Serial No. S840L628 - Remove
Phillips head screw and washer holding access
door to front panel. Refer to Figure 11.
c. Apply thumb pressure to right edge of door.
When door opens, move door to the left to
disengage from door supports. Refer to Figure
11.
d. Set fabric switch at normal. Place coins in slide
and carefully push in as far as possible on
meters models or set timer at “60’ minutes on
nonmetered models.
e. Close loading door and press push-to-start
button to start dryer.
Figure 41
DRY868S
Locknut
Dryer
Base
Leveling
Leg
Rubber
Pad