Service manual

216 800170
Section 6 Adjustments
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
137. CLEANING COIN DROP
a. Disconnect electrical power to machine and
drop.
b. Remove coin drop from machine. Refer to
Paragraph 87.
c. If lint is preventing coins from rolling through
coin drop, blow compressed air though coin
entry and along the side of the coin drop. Refer
to Figure 76.
d. Insert a coin through the coin drop. If coin does
not roll through drop, continue with the
following.
e. Remove cotter pin from top of drop. Refer to
Figure 76. Save pin for reinstallation when
cleaning is complete.
f. Move metal clip closer to sensor so that it
comes off frame. Refer to Figure 76.
g. Remove coin return from coin drop frame.
Refer to Figure 77.
h. Check coin path in coin drop for lint and
residue. If lint or light residues are present, use
a cotton swab to remove. If heavy residue is
present, it may be necessary to first scrape off
excessive residue and then use a cotton swab
dipped in water or isopropyl alcohol (rubbing
alcohol) to remove remainder of residue. Refer
to Figure 78.
Figure 76
DRY3B
Compressed
Air
Cotter
Pin
Metal
Clip
Figure 77
Figure 78
DRY4B
Coin Drop
Frame
Coin
Return
DRY5B
Cotton
Swab