Service manual

800170 213
Section 6 Adjustments
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
134. WASHER MOTOR BELT TENSION
NOTE: Belt adjustment procedures are done
through front of washer, however, as an option,
washer can be moved from its location and belt
adjustment can be done through lower access panel
opening on rear panel.
a. While supporting lower front access panel,
remove two screws from bottom edge of access
panel and remove panel. Refer to Figure 23.
b. Working through the access door opening,
place a locking pliers on the metal rod and
loosen the two adjusting bolts. Refer to
Figure 73. Repeat procedure to loosen the two
pivot bolts. Refer to Figure 73.
c. Pull down on motor to increase belt tension.
Use a Burroughs belt gauge to obtain proper
tension. Proper belt tension is obtained when
belt can be deflected approximately 1/4 inch
(6.35 mm) from normal position when
moderate pressure 50 to 60 pounds (22.68 to
27.22 Kg) is applied to a point midway between
pulleys. Refer to Figure 73.
d. After proper belt tension has been obtained,
tighten belt adjusting bolts firmly, then tighten
pivot bolts. Refer to Figure 73.
Figure 73
C
o
m
m
e
r
c
i
a
l
W
a
s
h
e
r
/
D
r
y
e
r
W
A
S
H
E
R
D
R
Y
E
R
H175SE3A
Adjusting
Bolt
Pivot
Bolt
Ground
Wire
Wire
Harness
Metal
Rod
Pivot
Bolt
Motor
Mounting
Bracket
Inner
Basket
Pulley
Belt
Motor
Pulley
1/4 inch
Adjusting
Bolt