Service manual

210 800170

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer/dryer before servicing.

• Close gas shut-off valve to gas dryer before servicing.

• Never start the washer/dryer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer/dryer is properly grounded.

W014R1

WARNING

b. Power Cord:

(1) Remove access plate on rear of cabinet.

(2) Remove strain relief.

(3) Remove screw holding power cord ground

wire to rear bulkhead. Refer to Figure 70.

NOTE: Reinstall screw and ground wires into same

hole in bulkhead when reinstalling power cord.

(4) Disconnect molex plug and remove power

cord from rear of dryer cabinet.

NOTE: A qualified electrician should check the

polarity of the wall receptacle. If a voltage reading

is measured other than that illustrated, the qualified

electrician should correct the problem.

Figure 70

D354SE3A

Ground

Neutral

Side

Dryer

Power Cord

115±12

V.A.C.

115±12

V.A.C.

Ground

Wires