Service manual

800170 19
Section 3 Troubleshooting (Washer)
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
SERVICE PROCEDURE: WORN BRUSHES
a. Remove motor from washer. Refer to Paragraph 100.
b. Using a flashlight, view brushes through holes in motor end shield. Refer to Figure 5.
c. Inspect both brushes to determine if either brush is worn. Refer to Figures 5 and 6.
d. Replace worn brushes with 738P3 Motor Brush Kit. Follow instructions provided in kit.
Figure 5
FLW1648S
Brush
Spring
GOOD BRUSH
– Has visible amount of
brush material remaining.
Brush
Holder
Brush
FLW1648S