Service manual

202 800170
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
125. CYLINDER BELT
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 40.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to Figure 48.
c. Remove two screws holding bottom tabs on
front panel to dryer side panels. Refer to
Figure 41. Swing bottom of front panel away
from dryer far enough to disengage hold-down
clips and locators from cabinet top.
d. Disconnect wires from door switch. Refer to
Figure 47.
NOTE: Refer to wiring diagram when rewiring
switch.
e. Disengage belt from motor and idler pulleys.
Refer to Figure 56.
f. Remove four screws holding bulkhead to front
flange of cabinet. Then, lift complete bulkhead
assembly out of slots in cabinet. Refer to
Figure 61.
IMPORTANT: When reassembling, be sure seal on
exhaust fan cover makes airtight seal on flange of
duct. Refer to Figure 53. If the seal is installed
improperly, the airflow through the exhaust system
will be restricted which can adversely affect dryer
performance.
g. While supporting cylinder, carefully remove
belt from cylinder.
NOTE: When reinstalling belt, be sure belt is
properly installed on motor and idler pulleys, and is
on the correct side of the idler lever. Refer to
Figure 56. Belt must be positioned around center
section of cylinder approximately three inches
ahead of rear rib on cylinder. Refer to Figure 65.
After installing belt, manually rotate cylinder
counterclockwise to check that belt is properly
aligned.
Figure 64
D307SE1C
Front
Bulkhead
Lint
Filter
To reduce the risk of serious injury or death
by carbon monoxide and other gases in
gas dryers, carefully read and follow all
instructions given in this section.
W005
WARNING