Service manual

800170 201

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer/dryer before servicing.

• Close gas shut-off valve to gas dryer before servicing.

• Never start the washer/dryer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer/dryer is properly grounded.

W014R1

WARNING

i. Front Cylinder Seal (Refer to Figure 63.)

When installing the cylinder seal, it is important

to remember these two steps:

(1) The stitching on the seal must face towards

center of dryer.

(2) The short flap must be glued to the

bulkhead and the long flap left loose.

IMPORTANT: The replacement seal can be

adhered to the bulkhead using No. 22506P Sealant.

This is accomplished by applying a bead of sealant

around the entire flanged area where the felt seal

contacts the bulkhead.

Figure 63

Bulkhead

Long Flap

Seal Stitching

(Must face towards

center of dryer)

Short Flap

(Must be glued

to bulkhead)

D257SE3A