Service manual

200 800170
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
124. DRYER FRONT BULKHEAD ASSEMBLY
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 40.
b. Gently lower the access panel to disengage
locators from bottom edge of front panel. Refer
to Figure 48.
c. Remove two screws holding bottom tabs on
front panel to dryer side panels. Refer to
Figure 41. Swing bottom of front panel away
from dryer far enough to disengage hold-down
clips and locators from cabinet top.
d. Disconnect wires from door switch. Refer to
Figure 47.
NOTE: Refer to wiring diagram when rewiring
switch.
e. Disengage belt from motor and idler pulley.
Refer to Figure 56.
f. Remove four screws holding bulkhead to front
flange of cabinet and lift complete bulkhead
assembly out of slots in cabinet. Refer to
Figure 61.
g. Remove air duct assembly.
IMPORTANT: When reassembling, be sure seal on
exhaust fan cover makes airtight seal on flange of
duct. Refer to Figure 53. If the seal is installed
improperly, the airflow through the exhaust system
will be restricted which can adversely affect dryer
performance.
h. Cylinder Glides and Glide Bracket. Refer to
Figure 62.
(1) Unsnap glide from each glide bracket.
(2) Drill out rivets holding glide bracket to
front bulkhead.
Figure 61
D394S
Cabinet Top
Hold-down
Screw
Front
Bulkhead
Cabinet Top
Hold-down
Screw
Bulkhead
Attaching
Screws
Bulkhead
Attaching
Screws
Slot
Cabinet
Attaching
Screw
Air
Duct
Cabinet
Attaching
Screw
Slot
Figure 62
To reduce the risk of serious injury or death
by carbon monoxide and other gases in
gas dryers, carefully read and follow all
instructions given in this section.
W005
WARNING
Cylinder
Seal
Cylinder
Glide
Cylinder
Glide Bracket
Rivets
D256SE3B