Service manual

800170 191
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
115. DRYER DOOR HINGE
a. Open loading door and, while supporting door,
remove four screws holding door assembly to
hinges. Refer to Figure 49.
b. Remove four screws holding hinges to front
panel. Refer to Figure 49.
116. DRYER HOLD-DOWN CLIPS AND
LOCATORS
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 40.
b. Gently lower access panel to disengage panel
locators from bottom edge of front panel.
c. Remove two screws holding bottom tabs on
front panel to dryer side panels. Refer to
Figure 41. Swing bottom edge of front panel
away from dryer far enough to disengage hold-
down clips and panel locators from cabinet top.
d. Disconnect wires from door switch. Refer to
Figure 47.
NOTE: Refer to wiring diagram when rewiring
switch.
e. Compress hold-down clips and remove from
top of front panel. Refer to Figure 48.
f. Remove four screws holding four locators to
access panel or front panel. Refer to Figure 48.
Figure 49
5
0
56
1
7
D184SE3A
Door
Hinges
Lint Filter
Attaching
Screw
Door
Attaching
Screws
Lint
Filter