Service manual

188 800170

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer/dryer before servicing.

• Close gas shut-off valve to gas dryer before servicing.

• Never start the washer/dryer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer/dryer is properly grounded.

W014R1

WARNING

112. DRYER FRONT PANEL AND PANEL SEAL

a. While supporting the access panel, remove two

screws from bottom edge of access panel. Refer

to Figure 40.

b. Gently lower the access panel to disengage

locators from bottom edge of front panel. Refer

to Figure 48.

c. Remove two screws holding bottom tabs on

front panel to dryer side panels. Refer to

Figure 41. Swing bottom of front panel away

from dryer far enough to disengage hold-down

clips and locators from cabinet top.

d. Disconnect wires from door switch. Refer to

Figure 47.

NOTE: Refer to wiring diagram when rewiring

switch.

e. Remove front panel seal from flange around

inside of door opening.

NOTE: Be sure seal is properly positioned when

installing on front panel.

Figure 47

Door

Switch

H183SE1A

Tabs