Service manual

800170 187

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer/dryer before servicing.

• Close gas shut-off valve to gas dryer before servicing.

• Never start the washer/dryer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer/dryer is properly grounded.

W014R1

WARNING

111. DRYER DOOR SEAL

a. Remove inner door panel from outer door

panel. Refer to Paragraph 109.

b. Grasp either end of door seal at bottom of door

and remove seal from tabs on inner door panel

by gently pulling on the seal. Refer to

Figure 46.

NOTE: When replacing seal, be sure seal is not

stretched or distorted. The tab in the seal should be

installed in each slot of the inner door panel, shown

in Figure 46. The split in the seal must be at the

bottom of the door. Make sure that each tab of the

seal is fully engaged into the slot.

Figure 46

H182SE3A

Door Seal

Tab

Inner Door

Panel

Door Seal

Inner Door

Panel Slot

Bottom Of Door