Service manual

184 800170
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
106. CABINET TOP
a. While supporting the access panel, remove two
screws from bottom edge of access panel. Refer
to Figure 40.
b. Gently lower access panel to disengage panel
locators from bottom edge of access panel.
Refer to Figure 40.
c. Remove two screws holding bottom tabs on
front panel to dryer cabinet. Refer to Figure 41.
d. Swing bottom of front panel away from dryer to
disengage hold-down clips and locators from
cabinet top.
e. Disconnect wires from door switch. Refer to
Figure 47.
NOTE: Refer to wiring diagram when rewiring
switch.
f. Remove two screws holding cabinet top to front
flange of cabinet. Refer to Figure 42.
g. Lift cabinet top to a vertical position by hinging
it on the rear hold-down brackets. Refer to
Figure 43.
NOTE: While servicing, cabinet top may be raised
and hinged on the rear hold-down brackets or
supported against wall behind dryer.
Figure 41
DRY977S
505617
Front Panel
Attaching
Screws
Figure 42
Figure 43
D394S
Cabinet Top
Hold-Down Screws
Cabinet
Top
D352SE1A
Rear
Hold-Down
Brackets