Service manual

164 800170

Section 5 Service Procedures

To reduce the risk of electric shock, fire, explosion, serious injury or death:

• Disconnect electric power to the washer/dryer before servicing.

• Close gas shut-off valve to gas dryer before servicing.

• Never start the washer/dryer with any guards/panels removed.

• Whenever ground wires are removed during servicing, these ground wires must be

reconnected to ensure that the washer/dryer is properly grounded.

W014R1

WARNING

95. MIXING VALVE

NOTE: Mixing valve is located on upper back right

corner of rear panel. Refer to Figure 26.

a. Go to rear of washer and remove screw holding

mixing valve and plate to rear panel, then

remove valve and plate out through opening in

rear panel. Refer to Figure 26.

b. Shut off external hot and cold water supply and

remove two inlet hoses.

c. Remove screws holding valve to mixing valve

plate. Refer to Figure 26.

d. Loosen hose clamp and remove mixing valve-

to-dispenser hose at the mixing valve. Refer to

Figure 26.

e. Remove wire harness disconnect blocks from

mixing valve solenoid terminals. Refer to

Figure 26.

NOTE: Refer to wiring diagram when rewiring

solenoids.