Service manual

800170 161
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
91. PRESSURE SWITCH
a. Go to rear of washer and remove screws
holding rear access panel to rear of control
cabinet. Refer to Figure 22.
b. Tilt access panel back far enough to disengage
bottom of access panel from opening in control
cabinet.
c. Disconnect wires from pressure switch at
disconnect block.
d. Disconnect pressure hose from pressure switch.
IMPORTANT: When installing pressure switch,
blow air into hose before connecting hose to switch
to remove any moisture that may have accumulated
in hose.
e. Squeeze locking tabs in on pressure switch and
push switch out toward rear of control shield.
Refer to Figure 22.
92. WASHER LOWER ACCESS PANEL
a. While supporting the lower access panel,
remove two screws from bottom edge of lower
access panel. Refer to Figure 23.
b. Gently lower the access panel to disengage
panel locators from bottom edge of front panel.
Figure 23
H176SE1A
Panel
Locators
Lower
Access Panel
Screws