Service manual

800170 149
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
84. INDICATOR LIGHT (Metered Models –
Washer Door Locked)
a. Unlock control panel. Refer to Figure 13, Step
1.
b. Pull top of control panel away from control
cabinet far enough to allow lifting control panel
up and off the rail support of the control
cabinet. Refer to Figure 13, Step 2.
c. Remove control panel away from control
cabinet as far as wires permit. Refer to
Figure 13, Step 3.
d. While supporting control panel, disconnect
wires from indicator light.
NOTE: Refer to wiring diagram when rewiring
light.
e. Squeeze locking tabs together and pull light out
rear of control panel. Refer to Figure 15.
Figure 15
W
A
S
H
E
R
D
R
Y
E
R
H161SE3A
Lock
Assembly
Cam
Electronic
Control
Screw
Control
Panel
Overlay
Indicator
Light
Control Panel
Assembly