Service manual

800170 147
Section 5 Service Procedures
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer/dryer before servicing.
• Close gas shut-off valve to gas dryer before servicing.
• Never start the washer/dryer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the washer/dryer is properly grounded.
W014R1
WARNING
82. CONTROL PANEL (Non-Metered Models)
a. Remove timer knobs from washer timer and
dryer timer shafts. Refer to Figure 14.
b. Pull temperature switch knobs off washer and
dryer temperature switch shafts.
c. Remove screws holding control panel to
control cabinet. Refer to Figure 14. Remove
panel as far as wires will permit.
83. CONTROLS (Non-Metered Models)
a. Remove control panel. Refer to Paragraph 82.
b. Disconnect two wires from indicator light.
NOTE: Refer to wiring diagram when rewiring
light.
c. Squeeze indicator light locking tabs together
and pull light out rear of control panel.
d. Disconnect wire harness from washer timer.
Remove timer from control panel. Refer to
Figure 14.
e. Disconnect wires from washer temperature
switch terminals. Remove screws holding
temperature switch to control panel. Refer to
Figure 14.
f. Disconnect wires from dryer temperature
switch terminals. Remove switch from control
panel. Refer to Figure 14.
NOTE: DO NOT pull on wires. Instead, unplug by
pulling on disconnect blocks. Use a pliers if
necessary.
NOTE: Refer to wiring diagram when rewiring
switch.
g. Remove wire harness and wires from dryer
timer. Remove timer from control panel. Refer
to Figure 14.
h. Remove control panel overlay from control
panel.
i. Remove control panel from unit.