Instruction manual

ManualsBrandsAlliance Laundry Systems ManualsHousehold AppliancesHTEB17*J99L1

511210

VFD Display Identification

Light Emitting Diodes (LEDs)

(Refer to Figure 1)

LIGHT EMITTING DIODES (LEDs) are used to

indicate the chosen temperature and cycle status. See

below for information on each LED.

INSERT COINS/CARD LED

The INSERT COINS/CARD LED is lit to prompt the

user to insert coins or a card to satisfy the vend price

for the chosen cycle. The LED is lit during the

“Ready” mode. During Partial and Additional Vend,

the LED flashes one second on and one second off.

The INSERT COINS/CARD LED will shut off when

the vend price has been satisfied.

START LED

The START pad LED flashes whenever the dryer is

not in a cycle, the full vend price has been satisfied,

and the dryer door is closed. When the START pad is

pressed, the cycle will begin or resume. The START

LED will shut off when the START pad is pressed.

The START LED will also flash any time a card is

inserted to add time to the current cycle.

DRYING LED

The DRYING LED is lit to indicate that one of the

heated cycles (HIGH TEMP, MED TEMP, LOW

TEMP) is currently in operation. The DRYING LED

goes off at the end of a heated cycle, if the heated cycle

is changed to a NO HEAT cycle, or when the COOL

DOWN cycle begins.

COOL DOWN LED

The COOL DOWN LED is lit whenever the COOL

DOWN portion of a heated cycle is active. It is also lit

when the NO HEAT cycle is in operation. The COOL

DOWN LED will shut off when a cycle ends or more

time is added, pushing the cycle back into the heated

portion of a cycle.

ADD TIME LED (Card Models Only)

The ADD TIME LED flashes alternately with the

REMOVE CARD LED when a card is inserted while a

cycle is running or when a card is left in the reader.

REMOVE CARD LED (Card Models Only)

The REMOVE CARD LED flashes one second on and

one second off when a card is inserted or left in the

reader after a transaction is complete. The REMOVE

CARD LED will also flash alternately with the ADD

TIME LED when a card is inserted while a cycle is

running or when a card is left in the reader.

Four 7-Segment Digits

The 7-SEGMENT DIGITS are used to display the

time remaining in a cycle, vend price, error messages

and descriptive codes. When displaying the time

remaining, the colon will flash. When displaying the

vend price, the decimal point may be lit. During

diagnostic testing or manual programming of the

control, these digits will display descriptive codes and

values (as described in Entering the Manual Mode).