Instruction manual

Programming NetMaster
69
511210
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
37. Set Real-Time Clock Century
“+037”
This option allows the owner to set NetMaster’s
internal clock to the correct century.
How to Program the Clock Century
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (+) or the NO HEAT (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 138
3. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to scroll through the programmable
options until “+037” appears in the VFD. Refer
to Figure 139.
Figure 139
4. When “+037” appears in the VFD, press the
START (enter) keypad. The current century will
appear in the VFD.
5. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to increase or decrease the century until
correct. Refer to Figure 140.
NOTE: The digits 20 are used for century.
Figure 140
6. Press the START (enter) keypad when the correct
century appears in the VFD. The next option,
“+038”, will appear in the VFD.
NOTE: To program “+038” (Heat Cycle Time
Minutes), refer to option 38. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the MED TEMP
keypad with one hand, press the LOW TEMP
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to Figure 2.
C762I
C780I
C848I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
C84
8
1
32