Instruction manual

Programming NetMaster
511210
68
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
36. Set Real-Time Clock Year
“+036”
This option allows the owner to set NetMaster’s
internal clock to the correct year.
How to Program the Clock Year
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (+) or the NO HEAT (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 135
3. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to scroll through the programmable
options until “+036” appears in the VFD. Refer
to Figure 136.
Figure 136
4. When “+036” appears in the VFD, press the
START (enter) keypad. The current year will
appear in the VFD.
5. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to increase or decrease the year until
correct. Refer to Figure 137.
NOTE: The year 2000 is 00, the year 2001 is 01 and
so on.
Figure 137
6. Press the START (enter) keypad when the correct
year appears in the VFD. The next option,
“+037”, will appear in the VFD.
NOTE: To program “+037” (Set Real-Time Clock
Century), refer to option 37. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the MED TEMP
keypad with one hand, press the LOW TEMP
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to Figure 2.
C762I
C797I
C848I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
C84
8
1
32