Instruction manual

Programming NetMaster

511210

35. Set Real-Time Clock Month

“+035”

This option allows the owner to set NetMaster’s

internal clock to the correct month.

How to Program the Clock Month

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the LOW TEMP (+) or the NO HEAT (-)

keypad until “PrOg” appears in the VFD. Press

the START (enter) keypad and “+001” will

appear in the VFD.

Figure 132

3. Press the LOW TEMP (+) or the NO HEAT (-)

keypad to scroll through the programmable

options until “+035” appears in the VFD. Refer

to Figure 133.

Figure 133

4. When “+035” appears in the VFD, press the

START (enter) keypad. The current month will

appear in the VFD.

5. Press the LOW TEMP (+) or the NO HEAT (-)

keypad to increase or decrease the month until

correct. Refer to Figure 134.

Figure 134

6. Press the START (enter) keypad when the correct

month appears in the VFD. The next option,

“+036”, will appear in the VFD.

NOTE: To program “+036” (Set Real-Time Clock

Year), refer to option 36. To program other options,

refer to the appropriate section.

How to Exit Programming Feature

1. Be sure the control shows a programmable option,

not a value.

2. While pressing and holding the MED TEMP

keypad with one hand, press the LOW TEMP

keypad with the other hand. The control will

revert back to the Ready Mode. Refer to Figure 2.

C762I

C796I

C848I

1 Press this pad (+) to scroll forward or increase a value

2 Press this pad (enter) to choose a selected value or

option

3 Press this pad (-) to scroll back or decrease a value

C84