Instruction manual

Programming NetMaster

511210

34. Set Real-Time Clock Date

“+034”

This option allows the owner to set NetMaster’s

internal clock to the correct day of the month.

How to Program the Clock Date

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the LOW TEMP (+) or the NO HEAT (-)

keypad until “PrOg” appears in the VFD. Press

the START (enter) keypad and “+001” will

appear in the VFD.

Figure 129

3. Press the LOW TEMP (+) or the NO HEAT (-)

keypad to scroll through the programmable

options until “+034” appears in the VFD. Refer

to Figure 130.

Figure 130

4. When “+034” appears in the VFD, press the

START (enter) keypad. The current day of the

month will appear in the VFD.

5. Press the LOW TEMP (+) or the NO HEAT (-)

keypad to increase or decrease the day of the

month until correct. Refer to Figure 131.

Figure 131

6. Press the START (enter) keypad when the correct

day of the month appears in the VFD. The next

option, “+035”, will appear in the VFD.

NOTE: To program “+035” (Set Real-Time Clock

Month), refer to option 35. To program other

options, refer to the appropriate section.

How to Exit Programming Feature

1. Be sure the control shows a programmable option,

not a value.

2. While pressing and holding the MED TEMP

keypad with one hand, press the LOW TEMP

keypad with the other hand. The control will

revert back to the Ready Mode. Refer to Figure 2.

C762I

C778I

C848I

1 Press this pad (+) to scroll forward or increase a value

2 Press this pad (enter) to choose a selected value or

option

3 Press this pad (-) to scroll back or decrease a value

C84