Instruction manual

Programming NetMaster
65
511210
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
33. Set Real-Time Clock Day “+033”
This option allows the owner to set NetMaster’s
internal clock to the correct day of the week.
How to Program the Clock Day
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (+) or the NO HEAT (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 126
3. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to scroll through the programmable
options until “+033” appears in the VFD. Refer
to Figure 127.
Figure 127
4. When “+033” appears in the VFD, press the
START (enter) keypad. The current day of the
week will appear in the VFD.
5. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to increase or decrease the day until
correct. Refer to Figure 128.
NOTE: Sunday is considered day one (001), Monday
is day two (002) and so on.
Figure 128
6. Press the START (enter) keypad when the correct
day appears in the VFD. The next option, “+034”,
will appear in the VFD.
NOTE: To program “+034” (Set Real-Time Clock
Date), refer to option 34. To program other options,
refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the MED TEMP
keypad with one hand, press the LOW EMP
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to Figure 2.
C762I
C779I
C848I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
C84
8
1
32