Instruction manual

Programming NetMaster
511210
64
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
32. Set Real-Time Clock Hours
“+032”
This option allows the owner to set NetMaster’s
internal clock to the correct time in hours.
How to Program the Clock Hours
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (+) or the NO HEAT (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 123
3. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to scroll through the programmable
options until “+032” appears in the VFD. Refer
to Figure 124.
Figure 124
4. When “+032” appears in the VFD, press the
START (enter) keypad. The current time in hours
will appear in the VFD.
NOTE: The hours will be displayed in military time.
5. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to increase or decrease the hours to the
correct time. Refer to Figure 125.
Figure 125
6. Press the START (enter) keypad when the correct
time in hours appears in the VFD. The next
option, “+033”, will appear in the VFD.
NOTE: To program “+033” (Set Real-Time Clock
Day), refer to option 33. To program other options,
refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the MED TEMP
keypad with one hand, press the LOW TEMP
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to Figure 2.
C762I
C780I
C848I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
C84
8
1
32