Instruction manual

Programming NetMaster

511210

6. Press the START (enter) keypad to enter the fifth

digit and display remaining four digits. The

active digit will flash one second on and one

second off. Refer to Figure 113.

Figure 113

7. Press the LOW TEMP (+) or the NO HEAT (-)

keypad to increase or decrease the value of the

active digit and the START (enter) keypad to

enter the value of the digit and advance to the

next digit.

8. Press the START (enter) keypad with the last

active digit. The next option, “+029”, will appear

in the VFD.

NOTE: To program “+029” (Power Fail Reset),

refer to option 29. To program other options, refer

to the appropriate section.

How to Exit Programming Feature

1. Be sure the control shows a programmable option,

not a value.

2. While pressing and holding the MED TEMP

keypad with one hand, press the LOW TEMP

keypad with the other hand. The control will

revert back to the Ready Mode. Refer to Figure 2.

C827I