Instruction manual

Programming NetMaster

511210

15. Special Vend A Heat Price

“+015”

This option allows the owner to set the vend price for a

heated cycle in Special Vend A.

The vend price programmed in this option is used for

all cycles except the NO HEAT cycle.

How to Program Special Vend A Heat

Price

1. Control must be in Manual Mode. Refer to

Entering the Manual Mode.

2. Press the LOW TEMP (+) or the NO HEAT (-)

keypad until “PrOg” appears in the VFD. Press

the START (enter) keypad and “+001” will

appear in the VFD.

Figure 62

3. Press the LOW TEMP (+) or the NO HEAT (-)

keypad to scroll through the programmable options

until “+015” appears in the VFD. Refer to

Figure 63.

Figure 63

4. When “+015” appears in the VFD, press the

START (enter) keypad. There are five digits in

the Special Vend A Heat Price. The fifth digit

will appear in the VFD and will flash one second

on and one second off. Refer to Figure 64.

NOTE: If vend price is $100.00 or more, the fifth

digit is “1”. If vend price is $99.99 or less, the fifth

digit is “0”.

Figure 64

5. Press the LOW TEMP (+) or the NO HEAT (-)

keypad to increase or decrease the value of the

fifth digit. Refer to Figure 65.

NOTE: The vend price can be set from 1 to 65,535.

Figure 65

C762I

C777I

C826I

C848I

1 Press this pad (+) to scroll forward or increase a value

2 Press this pad (enter) to choose a selected value or

option

3 Press this pad (-) to scroll back or decrease a value

C826I

C84