Instruction manual

Programming NetMaster
511210
36
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
12. Special Vend A End Month
“+012”
This option allows the owner to set the month that
Special Vend A will end.
How to Program Special Vend A
End Month
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (+) or the NO HEAT (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 51
3. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to scroll through the programmable
options until “+012” appears in the VFD. Refer
to Figure 52.
Figure 52
4. When “+012” appears in the VFD, press the
START (enter) keypad. The current end month
will appear in the VFD.
5. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to increase or decrease the end month to
the desired month. Refer to Figure 53.
If “0” is selected and Special Vend A is on,
Special Vend A will occur at the time or day of
week selected, regardless of the month.
Figure 53
6. Press the START (enter) keypad when the correct
month appears in the VFD. The next option,
“+013”, will appear in the VFD.
NOTE: To program “+013” (Special Vend A End
Date), refer to option 13. To program other options,
refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the MED TEMP
keypad with one hand, press the LOW TEMP
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to Figure 2.
C762I
C774I
C848I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
C84
8
1
32