Instruction manual

Programming NetMaster
35
511210
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
11. Special Vend A Start Date
“+011”
This option allows the owner to set the date that
Special Vend A will begin.
How to Program Special Vend A Start Date
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (+) or the NO HEAT (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 48
3. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to scroll through the programmable
options until “+011” appears in the VFD. Refer
to Figure 49.
Figure 49
4. When “+011” appears in the VFD, press the
START (enter) keypad. The current start date will
appear in the VFD.
5. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to increase or decrease the start date to
the desired date. Refer to Figure 50.
If “0” is selected and Special Vend A is on,
Special Vend A will occur at the time or days of
week selected, regardless of the date.
Figure 50
6. Press the START (enter) keypad when the correct
date appears in the VFD. The next option, “+012”,
will appear in the VFD.
NOTE: To program “+012” (Special Vend A End
Month), refer to option 12. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the MED TEMP
keypad with one hand, press the LOW TEMP
keypad with the other hand. The control will
revert back to the Ready Mode. Refer to Figure 2.
C762I
C773I
C848I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
C84
8
1
32