Instruction manual

Programming NetMaster
511210
18
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
2. Heat Vend Price “+002”
This option allows the owner to set the vend price for a
heated cycle. This vend price will be displayed in the
VFD when in the Ready Mode.
The vend price programmed in this option is used for
all cycles except the NO HEAT cycle unless Special
Vend or Site Code pricing is active.
Program this option whenever a heated cycle vend
price needs to be changed.
How to Program the Heat Vend Price
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the LOW TEMP (+) or the NO HEAT (-)
keypad until “PrOg” appears in the VFD. Press
the START (enter) keypad and “+001” will
appear in the VFD.
Figure 11
3. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to scroll through the programmable
options until “+002” appears in the VFD. Refer
to Figure 12.
Figure 12
4. When “+002” appears in the VFD, press the
START (enter) keypad. There are five digits in
the Heat Vend Price. The fifth digit will appear in
the VFD and will flash one second on, one
second off. Refer to Figure 13.
NOTE: If vend price is $100.00 or more, the fifth
digit is “1”. If vend price is $99.99 or less, the fifth
digit is “0”.
Figure 13
5. Press the LOW TEMP (+) or the NO HEAT (-)
keypad to increase or decrease the value of the
fifth digit. Refer to Figure 14.
NOTE: The vend price can be set from 1 to 65,535.
Figure 14
C762I
C764I
C826I
C848I
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
C826I
C84
8
1
32