Instruction manual

11
511210
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NetMaster Special Features
Programming NetMaster
NetMaster allows the dryer owner to program special
features with the use of the keypad. Audit, diagnostic,
cycle and vend information may be programmed and
retrieved by pressing keypad combinations.
For details on programming cycle and vend information,
refer to Programming NetMaster.
Collecting Audit Information
With NetMaster, the dryer owner is able to access
valuable audit information by using the Micro-Wand IIIE,
the Network, the Card Reader, or in manual mode.
Netmaster will record and display coin vault openings,
coins entered, service door openings, total dryer
cycles, total NO HEAT cycles, special vend options,
power failures, downloads, and others.
For detailed information on audit features, refer to
Collecting Audit Information.
NOTE: Additional audit information is retrievable
with the Micro-Wand IIIE, the Card Reader or the
Network. Refer to the appropriate instruction
manual.
Testing Machine and NetMaster
Functions
Special programmable diagnostic features built into
NetMaster allow the owner to test specific information
with the dryer in the Ready Mode. By opening and
closing the service door and then pressing various
sequences of keypads, the owner may perform the
following tests:
● Dryer Software Version
● Coin Vault Opening Test
● Coin Drop #1 Test
● Coin Drop #2 Test
● Start Pulse Test
● Dryer-On Temperature Test
● Thermistor Temperature Test
● Service Door Opening Test
● Machine Configuration Display
For detailed information on running diagnostic tests,
refer to Testing Machine and NetMaster Functions.
Sales Floor Feature
The NetMaster dryer has a built-in sales floor feature
used to display all the LED lights, the status words,
and the four digits with the colon and decimal point.
This function is designed to show potential customers
the high-tech features of NetMaster and to verify that
all segments of the VFD work.
For detailed information on using the Sales Floor
feature, refer to Sales Floor Feature.
Rapid Advance Feature
This feature allows the user to quickly advance
through an active dryer cycle or advance into a cycle
from the Ready Mode. This feature is useful when
tests must be performed immediately on a dryer in an
active cycle. In this case, the user can quickly advance
the cycle to the end, perform the required tests, and
return the dryer to the active cycle.
For detailed information on using the Rapid Advance
feature, refer to Rapid Advance Feature.
Clear the NetMaster Vend Feature
This feature allows the user to return NetMaster back
to Ready Mode if coins or a card have been entered but
the full vend price has not been satisfied. Refer to
Figure 2.
For more information on using the Clear Vend feature,
refer to Clear Vend Feature.
Communications Mode
This feature allows the dryer control to communicate
with the Micro-Wand IIIE, the Smart Card Reader, or
the Network Interface Board. This allows the dryer
control to be programmed and have its data read
without using the keypad.
For more detailed information on using the
Communications Mode feature, refer to
Communications Mode.
Dual Coin Drop
The control will accept pulses from a dual coin drop to
satisfy vend price. Each coin drop will have the ability
to start or run a cycle.