Instruction manual

115
511210
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Rapid Advance Feature
The Rapid Advance feature allows the owner to
quickly advance through active cycles or advance into
a cycle from the Ready Mode.
NOTE: This feature is only available if the Manual
Rapid Advance/Diagnostic Access is enabled.
How to Enter Rapid Advance from
Ready Mode
1. If control is in Ready Mode, control must be put
into Manual Mode. Refer to Entering the
Manual Mode.
2. Press the MED TEMP (+) or the LOW TEMP (-)
keypad until “rAPd” appears in the display.
3. Press the START (enter) keypad. The VFD will
display cycle time and the START (enter) keypad
LED will flash.
4. Press the START (enter) keypad to start cycle.
While in the Rapid Advance Mode, pressing the
START pad will advance the cycle time by one (1)
minute for every half second the keypad is held down.
NOTE: Door must be closed to start cycle.
How to Enter Rapid Advance During
an Active Cycle
1. Be certain access panel is open.
2. While pressing and holding the MED TEMP
keypad with one hand, press the LOW TEMP
keypad with the other hand. There will be no
change on the VFD display.
Control must be in the Manual Mode to use the Rapid
Advance feature.
While in the Rapid Advance Mode, pressing the
START pad will advance the cycle time by one (1)
minute for every half second the keypad is held down.
Continue pressing the START (enter) keypad until the
cycle is completed.
How to Exit Rapid Advance Feature
1. Advance through the cycles until reaching the
Ready Mode. Refer to Figure 2.