Instruction manual

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Error Codes
43
F8237801
Table 14 (continued)
Display Description
Cause/
Corrective Action
E do Door Open Error Control detects door open. Caused by pulling on door
while locked or about to lock. Correct inoperative door
locking system. End cycle. Power down machine to
clear.
E Ub Unbalance Error Unable to balance load. Redistribute load and run cycle.
door Door Open Indicator Door is not closed in Start Mode. If door is closed, check
for improper wiring or faulty door switch.
E dr Drain Alarm Error Machine not drained within 15 minutes (or other
programmed length of time) in any drain step. End
cycle. Power down machine to clear.
E Ht Heat Alarm Error Programmed heat alarm time of 120 minutes or other
programmed length of time is exceeded. Turns off heater
output for remainder of cycle.
E oP Open Temperature Sensor Error Control senses temperature less than 0°F (-18°C) in
machine equipped with temperature sensor. Heater and
thermistor related operations are disabled for remainder
of cycle.
E SH Shorted Temperature Sensor Error Control senses temperature greater than 220°F (104°C)
in machine equipped with temp sensor. Heater and
thermistor related operations are disabled for remainder
of cycle.
E ro Rotation Sensor Error Invalid signal received from Rotation Sensor. Control
will activate coast times to complete cycle.
E FS Frame Balance Switch Error Control detects Frame Balance Switch open. End cycle.
E db Drive Balance Switch Error Control detects VFD Balance Switch input closed at
start of drain step. End cycle. Power down machine to
clear.
E Ld Water Leak Detection Error If control senses a drop in water level during diagnostic
testing. Power down machine to clear. When error
occurs during a cycle, “
ELd” is displayed for one
minute after opening the door at the end of the cycle and
lights the right-most decimal point* on the display.
When the error occurs during a test, “
ELd” is displayed
immediately after the test until the machine is powered
down to clear the error.
E Sd Slow Drain Error If control shows error after door is open (when cycle is
completed) for one minute and lights the right-most
decimal point* on the display, the error information will
be logged in audit data.
* To clear the decimal point on display, press the START (enter) keypad 3 times in succession (within 5 seconds).
Table 14 (continued)