Instruction manual

F8237801

Error Codes

Following is a list of possible error codes for an

electronic control. Errors beginning with “EI” refer to

external device Infra-red communication errors. All

other errors refer to machine errors.

Display Description

Cause/

Corrective Action

EI01 Transmission Failure Communication failure. Re-aim external device and try

again.

EI02 Time-out Error Communication failure. Re-aim external device and try

again.

EI03 Invalid Command Code Communication successful, but the command was not

valid for this machine type, or the control could not

perform the command in its current mode of operation.

Ensure data is for current machine type and control is in

correct mode.

EI04 Expecting Upload Request Communication failure. Re-aim external device and try

again.

EI05 Invalid or Out-of-Range Data The value in at least one of the programming options is

invalid or out of range. Recheck the programming

option’s value and try again.

EI09 CRC-16 Error Communication failure. Re-aim external device and try

again.

EI0A Framing Error Communication error. Re-aim external device and try

again.

EI0C Time-out Exceeded Communication error. Re-aim external device and try

again.

EI0E Encryption Error Communication error. Re-aim external device and try

again. If the problem persists, check that the security

code is correct.

EI0F Infra-red Disabled Communication failure or infra-red is disabled.

Manually enable infra-red on control or re-aim external

device and try again.

E FL Fill Error Water level not reached within 10 minutes in any fill

agitate cycle. End cycle. Power down machine to clear.

E SP SPI Communications Error Front End control cannot communicate with output

board. Power down the machine, power up and try

again.

E dL Door Lock Error Door does not lock immeadiately upon closing (open

and reclose door) or doesn’t unlock 5 seconds after cycle

completion. Power down machine and retry.

Table 14 (continued)