Instruction manual

Testing Machine and Electronic Control Functions

F8237801

Table 13 (continued)

Production Test Cycle Quick Reference Chart

Display Test Mode Comments

“xxxF” degrees F or

“xxxC” degrees C

depending on the

Fahrenheit/Celsius

programming parameter

Heat water to 110°F or display temperature xxx is degree temperature. This step

skipped if not model with heat. Heater

turned off when temperature reached.

“LoAg” Reduced Wash Speed Forward with no agitation

action

This step skipped on 2 Speed models.

“Ag” Wash Speed Forward with no agitation action

“rAg” Wash Speed Reverse with no agitation action

“drAI” Drain Distribution Speed

“PUrg” Factory Valve Purge

“SP 1” Extract Speed #1 “very low” This step skipped on 2 Speed models.

“SP 2” Extract Speed #2 “low” This step skipped on 2 Speed models.

“SP 3” Extract Speed #3 “medium” This step skipped on 2 Speed models.

“SP 4” (VFD Models) or

“SPIn” (2 Speed Models)

Extract Speed #4 “high” Design 2 models only. This step skipped on

F-Speed Models.

“SP 5” Extract Speed #5 “ very high” Design 2 models only. This step skipped on

2 Speed and F-Speed Models.

“SP 6” Extract Speed #6 “ultra high” Design 2 models only.

“Prdn” End of test Turn Power off.

Table 13